Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: paradigm shift
Showing results 1 to 4 of 4
Search took 0.01 seconds.
Forum: General Q & A
05-10-2004, 11:39 PM
Replies: 13
Views: 6,071
Posted By paradigm shift

I doupt if you will see much difference in oil...

I doupt if you will see much difference in oil pressure with synthetic but you will have added protection. You can remote mount the cooler and plumb to it. That is how mine is set up for the same...
Forum: General Q & A
05-10-2004, 07:05 AM
Replies: 13
Views: 6,071
Posted By paradigm shift

Well there has been a fair amount of debate on...

Well there has been a fair amount of debate on where is the best location for oil temp gauge sensor. Many mount them in the pan. Some run 2 sensors one going to the cooler and one on the return. I...
Forum: General Q & A
05-09-2004, 10:53 PM
Replies: 13
Views: 6,071
Posted By paradigm shift

Sure sounds like your oil is getting hot. Without...

Sure sounds like your oil is getting hot. Without a gauge who know where it is at though. 115 air temp where you at?

I have run a Dooley oil cooler before with good luck. Pretty popular with the...
Forum: General Q & A
05-09-2004, 01:02 PM
Replies: 13
Views: 6,071
Posted By paradigm shift

A high vlume pump should not run the sump dry if...

A high vlume pump should not run the sump dry if your clearances are correct. Usually you can tell if oil is foaming by pulling the dip stick after a hard run.

Question though is your oil pressure...
Showing results 1 to 4 of 4


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.