Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: mjb
Showing results 1 to 7 of 7
Search took 0.01 seconds.
Forum: General Q & A
08-21-2006, 08:53 AM
Replies: 17
Views: 6,911
Posted By mjb

Re: which advance reading on RINDA scan tool ???

I was able to do a little testing this weekend. It turned out to be a bad distributor module on my new MSD distributor. I replaced the module with the old one from my original mercruiser...
Forum: General Q & A
08-16-2006, 01:57 PM
Replies: 17
Views: 6,911
Posted By mjb

Re: which advance reading on RINDA scan tool ???

Thanks Dave- I'll post a follow up when I have done some more homework.
Forum: General Q & A
08-16-2006, 09:50 AM
Replies: 17
Views: 6,911
Posted By mjb

Re: which advance reading on RINDA scan tool ???

Dave- thanks for the info...there is only a single wire going to my knock sensor. With only one wire, how could the knock sensor SEND a voltage signal to the emc? Where would the voltage come from?...
Forum: General Q & A
08-15-2006, 01:01 PM
Replies: 17
Views: 6,911
Posted By mjb

Re: which advance reading on RINDA scan tool ???

Dave- Could you please clarify your comment #3 pertaining to the knock sensor.
In a properly running engine, is a code 44 set anytime the knock sensor is working and pulls out timing... or is it set...
Forum: General Q & A
08-14-2006, 03:13 PM
Replies: 17
Views: 6,911
Posted By mjb

Re: which advance reading on RINDA scan tool ???

Thanks Dave- I'll try your suggestions this weekend and repost my results.
Forum: General Q & A
08-14-2006, 02:01 PM
Replies: 17
Views: 6,911
Posted By mjb

Re: which advance reading on RINDA scan tool ???

Dave- you were just one of the ones I was hoping to hear from....My timing light(new MSD non advance) at 3500 RPM is showing about 4-6 degrees less advance than my scan tool on my starboard engine...
Forum: General Q & A
08-14-2006, 10:47 AM
Replies: 17
Views: 6,911
Posted By mjb

which advance reading on RINDA scan tool ???

I'm having a timing issue on one of my 502 MEFI 1's. Maybe some efi guru's can help with this question.
At cruising speed(3500 RPM)I understand that the ECM selects the baseline timing advance from...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.