pachangalpina

If anyone is interested, I can engrave the steering wheel centers with the Fountain Logo. You will have to send me your center and the turn around time will be a few days. If you need other parts engraved let me know

I also still have some of the rubrail trim caps still available.

Todd

Back4More

MasterCam?

gferdon

Cost??

pachangalpina

Laser engraved.

cost will be $5 plus shipping. Most locations in the US will be about $3.50 for FedEx.

Since these will be done one at a time, we may have to do a small test engraving on the back side to ensure the best quality engraving. If you have a silver part the engraving will show as a matt silver/white engraving.

If you wish to have yours done, just send the center piece and a check to:

Todd Howerton
Outlaw Disc Brakes
1465 Ventura Drive
Cumming GA 30040
770-844-1777

Thanks, Todd

Back4More

If you want i have the "FOUNTAIN" word in geometry i could send you...just pic a format.

pachangalpina

Back4More,

That would be great. The version that I have is scanned and works fine for the small trim piece but is not good for the larger stuff without a lot of clean-up. Jpeg is probably the easiest to work with in the lasering software.

Thanks, Todd

toddh@outlawdiscbrakes. com

gferdon

My wheel center is made of plastic and has the "Gaffrig" logo on it...too bad, I would have liked to have the Fountain logo, looks great!

GCF

pachangalpina

Eric, I got your phone message but you did not leave your number. But yes, I can still do these.

Thanks, Todd