New to me Skater.
#1
Registered
Thread Starter
New to me Skater.
This is headed north.
It is a project but pretty much what I was looking for.
I am ready!
Any other 46 owners who can assist me with some measurements and questions please help.
I have to admit the size is overwhelming but as the day progressed it actually seem to get smaller.
Thanks in Advance
Gerry
It is a project but pretty much what I was looking for.
I am ready!
Any other 46 owners who can assist me with some measurements and questions please help.
I have to admit the size is overwhelming but as the day progressed it actually seem to get smaller.
Thanks in Advance
Gerry
#2
Registered
Thread Starter
Re: New to me Skater.
It has a full pleasure cockpit with a small cabin below.
my plan is to install my piston engines.
Gerry
my plan is to install my piston engines.
Gerry
Last edited by caveman; 01-27-2006 at 08:47 AM.
#3
Registered
Thread Starter
Re: New to me Skater.
I could use one of these.
#6
Registered
Thread Starter
Re: New to me Skater.
Off the top of my head came.
KNOT-RIGHT
KNOT-RIGHT
Last edited by KNOT-RIGHT; 01-08-2007 at 07:35 PM.
#7
Registered
Thread Starter
Re: New to me Skater.
Peter at Skater called me today and will give some of the measurements needed to go back to pistons.
1000hp with # 6,s need ratio 1.35 figure 32 props
Drive shaft lenth from 24-30 inches.
Anyone can measure theres?
Need drive shaft lenth from transmission flange to
#6 flange.
also Crankshaft center line to bottom of hull
or any measure that will give me engine height.
a photo would be worth 1000 words.
Gerry
1000hp with # 6,s need ratio 1.35 figure 32 props
Drive shaft lenth from 24-30 inches.
Anyone can measure theres?
Need drive shaft lenth from transmission flange to
#6 flange.
also Crankshaft center line to bottom of hull
or any measure that will give me engine height.
a photo would be worth 1000 words.
Gerry
#9
Registered
Join Date: Mar 2002
Location: Sand Springs/Grand Lake oklahoma
Posts: 975
Received 0 Likes
on
0 Posts
Re: New to me Skater.
You need to contact: FREEDOMUS1
He knows alot about the 46's
http://www.offshoreonly.com/forums/p...m&userid=56855
He knows alot about the 46's
http://www.offshoreonly.com/forums/p...m&userid=56855
#10
Registered
Thread Starter
Re: New to me Skater.
Originally Posted by apache21
You need to contact: FREEDOMUS1
He knows alot about the 46's
http://www.offshoreonly.com/forums/p...m&userid=56855
He knows alot about the 46's
http://www.offshoreonly.com/forums/p...m&userid=56855
I have been in contact with Jim.
I asked him to teach me how to run it.
Sweet ride he has..
Gerry