Questions about driving a 32 Spectre
#1
Registered
Thread Starter
Join Date: Apr 2013
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
Questions about driving a 32 Spectre
I bought a 2006 32 with twin 625 ilmores with set back boxes with sportmaster drives my last 2 boats where 28 eliminator daytonsa with twin 525s. which is a complete dif animal. I am still getting used to the spectre. I havnt really ran it that hard yet. But at about 100 mph It starts to chine walk a little. I usually back out of it. Because have never had a cat do that. Any help would greatly be appreciated thanks again
#2
Registered
Join Date: May 2010
Location: Sarasota, Fl
Posts: 249
Likes: 0
Received 0 Likes
on
0 Posts
I bought a 2006 32 with twin 625 ilmores with set back boxes with sportmaster drives my last 2 boats where 28 eliminator daytonsa with twin 525s. which is a complete dif animal. I am still getting used to the spectre. I havnt really ran it that hard yet. But at about 100 mph It starts to chine walk a little. I usually back out of it. Because have never had a cat do that. Any help would greatly be appreciated thanks again
#4
Registered
Mine doesn't do it at all. Its rock solid to 130 MPH. tends to porpoise a little at about 70 MPH, but down trim or more power gets through that.
#5
Registered
Thread Starter
Join Date: Apr 2013
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
All ive learned so far is my props are supposed to have the hubs cut down about 5/8 of an inch. But not sure if that alone could make it chine walk. But so far not real happy with spectre!!! Starting to think i should of stayed with Eliminator.
#6
Registered
Is it this boat?
This is my old boat & it ran smooth up to 120mph, only porpoised in flat water full on fuel & passengers. Otherwise rock solid.
#7
Registered
Thread Starter
Join Date: Apr 2013
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
No mine is red and silver. Saw yout old boat on you tube. Nice looking boat. I am not sure what it is. what motors did you have in yours? I was told mine would run over 130mph. I am not sure what the issue is. up to 110 mph it runs well. but at 100 it starts to walk. And at that speed i dont feel real comfortable with it chime walking. ive played with the trim. on yours did you have the hub of the propped cut down? I spoke to jay Pillini And he said it was a must on a merc bravo 4 blade?
#9
Registered
PM me your # & ill call you. Yes my boat had ILMOR 625's w/ Teague Platinum drives. I know your boat & the original owner. Nice boat & ran well.
Merc Bravo1 4 blade 34's w/ the diffuser ring cut off.
I bought my boat from Nick Buis, who is now a principal in Statement Marine. He's someone else that could assist you.
Merc Bravo1 4 blade 34's w/ the diffuser ring cut off.
I bought my boat from Nick Buis, who is now a principal in Statement Marine. He's someone else that could assist you.