pair 30" Bravo 1 labbed props brand new
#1
Registered
Thread Starter
Join Date: Jul 2006
Location: The Sunshine State
Posts: 340
Likes: 0
Received 0 Likes
on
0 Posts
pair 30" Bravo 1 labbed props brand new
Here is a pair (left and right) of Brand New 30" merc labbed bravo 1 props. AOIUL and COIUL. 15.25 x 30" Never even had a hub slid into them. No nics or dings of any kind. Shipped in Merc cardboard prop boxes. No hubs included. $1161 each retail. $1200 OBO for the pair plus shipping.
Thanks for looking.
Adam
Thanks for looking.
Adam
#2
Registered
Adam,
Who did the lab work, what was changed, what hull were they set up for and what kind of results did you see? I have a new set of Bravo 30's that need to be labbed but if these might work....
Thanks,
Rick
Who did the lab work, what was changed, what hull were they set up for and what kind of results did you see? I have a new set of Bravo 30's that need to be labbed but if these might work....
Thanks,
Rick
#3
Registered
Thread Starter
Join Date: Jul 2006
Location: The Sunshine State
Posts: 340
Likes: 0
Received 0 Likes
on
0 Posts
Rick,
Thanks for the interest. These are labbed by Merc Racing. The serial numbers are in my description above. They are not set up for any particular hull design. It is a general lab finishing where they thin the blades, etc. Typically you would gain 200rpm with these props over standard 30" bravo 1s or they would spin the same rpm as a 28" standard bravo 1s. You could custom tweak from these as a baseline if you were to so choose. The Merc part numbers are 48-831917L65 and 48-831918L65. There are no results to share as these are brand new. They have never been on a boat. Hope this helps.
Adam
PS If the hull you are looking at these for is a straight V, I also have a set of 31" bravo 1s with tip cup added. The tip cup helps the prop bite harder to carry the bow on straight V bottoms.
Thanks for the interest. These are labbed by Merc Racing. The serial numbers are in my description above. They are not set up for any particular hull design. It is a general lab finishing where they thin the blades, etc. Typically you would gain 200rpm with these props over standard 30" bravo 1s or they would spin the same rpm as a 28" standard bravo 1s. You could custom tweak from these as a baseline if you were to so choose. The Merc part numbers are 48-831917L65 and 48-831918L65. There are no results to share as these are brand new. They have never been on a boat. Hope this helps.
Adam
PS If the hull you are looking at these for is a straight V, I also have a set of 31" bravo 1s with tip cup added. The tip cup helps the prop bite harder to carry the bow on straight V bottoms.