Bravo transom assembly
#1
Registered
Thread Starter
Bravo transom assembly
I have a used bravo transom assembly that will need rebuild. Have most parts for this was taken off and replaced with an HD assembly. Ring is in great shape, gimbal and helmet as well. Just really needs new bellows, shift cable and bushing ect..... Have the old top steering pin blasted and all cleaned up, you decide is you want to use or not. Missing the tilt rams and lower steering pin on the bottom. Make a reasonable offer plus the ride and it is your.
[ATTACH=CONFIG]505048[/ATTACH][ATTACH=CONFIG]505049[/ATTACH][ATTACH=CONFIG]505050[/ATTACH]
[ATTACH=CONFIG]505048[/ATTACH][ATTACH=CONFIG]505049[/ATTACH][ATTACH=CONFIG]505050[/ATTACH]
#4
Registered
Thread Starter
Nobody has a busted ring or next parts? This is a nice complete setup with the Steering pin for cheap. I see rings selling for 400.00 alone and pins for 200.00. Good deal for cheap parts.
#7
Can you provide a good closeup picture of gimbal housing where the steering pin goes through from the outside ..specifically the stepped area that is supposed to hold a seal .
Also a picture inside square hole at top of gimbal ring ...thank you
Also a picture inside square hole at top of gimbal ring ...thank you