aluminum swimplatform off 7 foot boat
#16
Registered
I have one that has brand new white powder coating..........never seen the light of day. I will sell for $500. After powder coating I decided not to put it back on. I'll tell you right now I had it on here like a year and a half ago for sale. Had many request. The problem was/is that it has 3 mounting brackets. Obviously one on each end and smack dead center. So, if it's a twin engine boat and the exhaust exits below the rub rail (mine does not.......mine is above) there could be clearance problems. It of course depends how close from each other the 2 center pipes are. However, with that said no matter how close they are you could certainly trim the center bracket. This swim platform came off a Sutphen which has a flat transom. All the brackets are therefor in line.
#18
Registered
8' I do have a picture, but am somewhat challenged on how to put it on here. I can take the engines out of my boat, rebuild them, etc. Buuuuuuuuut I can't upload a picture. WTF! Give me your e-mail address and I would be happy to send a picture that way.
#19
Registered
Join Date: Nov 2002
Location: Huntersville, NC
Posts: 641
Likes: 0
Received 0 Likes
on
0 Posts
I doubt it would work on my 7' beam boat. But sure send it to me and I'll attach it here at least. panteralkn at gmail
#20
Registered
I just took a quick measurement. It's approximately 82'' X 29". The brackets are from the center one to the outside ones a bit more than 29". I will send the picture right now.