Misc BBC 454 parts - heads, intake, Thunderbolt 4 dist complete, valve covers etc.
#13
do you have the front engine pedestal mounts, i'm looking for the part that bolts to the block, both of them
#14
Gen 4 - Thunderbolt 4 distributor with module, cap, wires, coil and new electronic pick up $ 150.00 shipped
i'll take it, pending pics, it's all good yes?
pm'd my email
thanks
i'll take it, pending pics, it's all good yes?
pm'd my email
thanks
#15
Registered
Thread Starter
iTrader: (2)
Join Date: Feb 2015
Location: North East MD
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
outonsafari - no engine mounts -
I will get you pics this afternoon - came off my running motor in fall - I am changing to HEI set-up. The coil (have 2 coils), cap, rotor, wires, and module in dist were all replace last Aug. It was falling on its face when I would try and run above 3000 rpms - thought it was electrical - ended up being bad fuel pump.
I will get you pics this afternoon - came off my running motor in fall - I am changing to HEI set-up. The coil (have 2 coils), cap, rotor, wires, and module in dist were all replace last Aug. It was falling on its face when I would try and run above 3000 rpms - thought it was electrical - ended up being bad fuel pump.
#17
Registered
still have intake? just picked up a set of heavily ported ovals and my oval intake will barely work at best. close enough to come get it. I can always justify a trip to eastern marine...
#20
Registered
Thread Starter
iTrader: (2)
Join Date: Feb 2015
Location: North East MD
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
Matt. I will send a few pics. They were removed and cleaned last winter. And then reinstalled used most of last summer. Came off running boat. I didn't have any issues. The boat was mostly fresh water.