WANTED 2 ANSON Turbosystems knock gauge
#1
Registered
Thread Starter
Join Date: Nov 2007
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
WANTED 2 ANSON Turbosystems knock gauge
HI
I am looking for 2 Anson Turbosystem engine knock meters or equivelent?
It seems theey may have gone out of bussiness?
Any suggestions on where to buy a set would be helpful
Thanks Bruce
I am looking for 2 Anson Turbosystem engine knock meters or equivelent?
It seems theey may have gone out of bussiness?
Any suggestions on where to buy a set would be helpful
Thanks Bruce
Last edited by Bruce; 12-03-2012 at 01:20 PM. Reason: spelling
#2
Registered
iTrader: (4)
I can't find anything for them either. I am thinking of using an existing knock module off a TBV or a GM knock module. I will hookup the knock sensor and when the module senses knock from the sensor I will use that signaled 8v-12v sourced from the module to source ground (-) off of a relay to my ignition. This will then pull the preset timing retard out. I assume you have Crane Hi-6m's also. I have schematics of my system on my home computer.
#3
Registered
Thread Starter
Join Date: Nov 2007
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
knock gauge
I have a mephi 4 so it will retard the timing but I just want to be able to see if it is knocking. I had one in my last boat and twice I had bad fuel on the lake and it sure was nice to know!!
I was hoping a supplier might have some in old stock??
I was hoping a supplier might have some in old stock??