|
Tantrum motor !
3 Attachment(s)
Finally got the motor back for the tantrum . going to finish reassembly this week and try to have it installed by next weekend . [ATTACH=CONFIG]507270[/ATTACH][ATTACH=CONFIG]507271[/ATTACH][ATTACH=CONFIG]507272[/ATTACH]
|
how is the boat running since you put it back together?
|
just got it cranked Thursday night seems fine just needs some carb adjusting .probably take it out next sunday .
|
cant get the drive on now ....
|
because the motor is not aligned? or some other reason?
|
Originally Posted by state1310
(Post 3999961)
cant get the drive on now ....
you can verify this by removing the o rings and try installing the out drive I bet it will slide all the way in,,,I just start a nut on each side and slowly tighten evenly and it goes right in.. if it was the alignment you would not be able to push the outdrive that far in.. the prop does not turn because your in gear |
Originally Posted by boatnt
(Post 4000015)
had that happen numerous times,,if its just the last 3/4" that wont go in most likely its the 2 larger o rings on the shaft binding when they hit the gimbal bearing,,
you can verify this by removing the o rings and try installing the out drive I bet it will slide all the way in,,,I just start a nut on each side and slowly tighten evenly and it goes right in.. if it was the alignment you would not be able to push the outdrive that far in.. the prop does not turn because your in gear |
Originally Posted by My Addiction
(Post 3999991)
because the motor is not aligned? or some other reason?
|
So....was it the o rings?
|
havent messed with it since the alignment tool got here
|
| All times are GMT -5. The time now is 01:02 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.