Lets talk gauge wiring.
#1
Registered
Thread Starter
Lets talk gauge wiring.
The purple wires are tied to the blue wires (purple being ignition & blue being lights)
When I stick a continuity meter on the ground it says there is continuity between the ground, purple (I) & blue leads (L). That doesn't seem right to me.
Should I not be Bud Lighting it while on this project?
I think I hooked everything back up the way it was, but I'm not sure now.
When I stick a continuity meter on the ground it says there is continuity between the ground, purple (I) & blue leads (L). That doesn't seem right to me.
Should I not be Bud Lighting it while on this project?
I think I hooked everything back up the way it was, but I'm not sure now.
#2
If the bulbs are in, you'll see continuity between ground and hot. Guess it depends on which side of the switch you are testing.
__________________
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.