Originally Posted by mgoblue06 (Post 3772996)

Got the cabinets started going back in today as well as cutting the piece of cuddy floor and laid a layer of 1708 on each side of that. Planning on glassing that into place tomorrow night.

I think for the first step to the windscreen I am going to reassemble the frame for the windshield and make some templates off of that then start fitting to the boat later in the week. I can see the light at te end of the tunnel of fiberglassing! The windscreen is the last of it.

Originally Posted by mgoblue06 (Post 3772478)

Update

Fiberglassed the hull to the deck today, use 4 inch strips of 1708 and staggered the joints between layers. Thing feels rock solid! Really glad I did it. Also getting little things buttoned up on the engine and tranny before putting it back in the boat next week hopefully. Would like to hear her purr by October 1st.

Next step is to get the cabinets installed and start rerigging while prepping for paint.

Not sure what I want to do with paint yet. 3 options.

1. Base/clear -more expensive and don't have any experience laying down clear
2. Single stage with painted graphics- easier to paint and cheaper than base clear, but have little paint lines from taping off different colors
3. Single stage with vinyl graphics

Opinions?

Originally Posted by Knot 4 Me (Post 3776730)

Formula applies Imron without clear so you have a hard edge on all the graphics. Doesn't really seem to be a big deal for them. If you have experience with single stage, I'd go that route. Painted graphics too over vinyl.

Originally Posted by Full Force (Post 3778923)

If you need spare parts, I am picking up a 250 Force for parts tonight...

http://www.offshoreonly.com/forums/s...orce-ohio.html

Originally Posted by XT-Innovator (Post 3779394)

I am interested in the windshield parts. Could affect the pricing on your Cig. interior????

Originally Posted by mgoblue06 (Post 3777153)

Any idea how much paint I will probably need?