Yes, I'll eventually will have it soda-blasted and painted....or I'll just sell it and replace it with an aluminum trailer that will handle the salt water better...

Finally hit the water for the first time this past monday. Stll have some gremlins to iron out but she ran pretty strong!

nice dude!

congrats!

2nd time on the water. Turning BIG Suzuki 4-blade 15"X24 pitch props we saw 67MPH at 5700 rpm with more in it. Switching to some Merc Chopper 26's should yield some more rpm at top end speed numbers. I hoping for 6400 rpm at about 74MPH. Boat ran well and we stayed out on the water for dinner. Here's some pics and a quick video:

http://www.youtube.com/watch?v=ScFAXJSkrwc

Good for you Dude!
It appears Mama likes it too :thankyouthankyou:

My new props arrived yesterday! I bought a pair of Mercury 26 pitch choppers worked by DAH. They need a little cleaning up but I'll run them first to get a base line of performance. I need to replace some bad motor mounts on my port motor..hopefully I'll get time to work on the boat this sunday and try the props.

great pics. jup are they bone stock 200's? if so your set up is doing better then me with setting it up. i am about 6 or 800 lbs heavier than you i think but same hull i believe. best i have seen is 63 on gps so you are off to a good start. love the engine video. love lookin back at twin egg beaters.

Yes, the are stock 2.4 Merc 200's mounted on one piece exhaust plates, 25" mids, and Bob's coned lower units.. Motors are on Gil brackets and set back 24" at 18" centers..

Ran my new DAH 26 pitch choppers last sunday. Netted 71.11 MPH @ 6000 rpm on the right motor and 5800 rpm on the counter rotating motor. That was with 96 gallons of gas and two adults. I think with more seat time, light on gas, some new reeds and I can sneak up on 75 mph!! Not to shabby for a couple of fishing motors!!!

For stock 200's you are hauling the mail....I am impressed.