Offshoreonly.com

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   Chris Craft (https://www.offshoreonly.com/forums/chris-craft-155/)
-   -   Question for you lil stinger guys (https://www.offshoreonly.com/forums/chris-craft/139084-question-you-lil-stinger-guys.html)

Fenderjack 08-28-2006 09:49 PM

Question for you lil stinger guys
 
i have been reading some of the posts and people are saying that the hull isn't desighned to go over say 70ish. Is this beacause of the lack of support in the hull or what. Just curious. I have talked to guys on other sites and a few guys at some of the big sponsor sites and they have said they have seen these boats particualy the 202,s and 22's in the high 70's- mid 80's without issue. I am just wanting to know this b4 I decide to fix this motor mount, if the case is lack of support i will just doulbe up the stringers from front to back. Thanks for any info on this matter guys..... JOHN

psmith 08-29-2006 12:22 PM

Re: Question for you lil stinger guys
 
[B]I have not herd of any support problems, but your already there then beef it up.

Wally 08-29-2006 02:39 PM

Re: Question for you lil stinger guys
 
i dont know about mid 80's without issue....i think its all i the setup of the boat. Going that fast in the 202 or the 222 i would have atleast the 280 k-planes and hydraulic steering. I think at the higher speeds with any smaller boat you just start to run out of bottom for the boat to remain stable on.....

Fenderjack 08-30-2006 10:54 PM

Re: Question for you lil stinger guys
 

Originally Posted by Wally
i dont know about mid 80's without issue....i think its all i the setup of the boat. Going that fast in the 202 or the 222 i would have atleast the 280 k-planes and hydraulic steering. I think at the higher speeds with any smaller boat you just start to run out of bottom for the boat to remain stable on.....

Yes i agree with the the boat will absolutly have k planes on it, dunno bout the hyd steering yet but that will come. I currently have a cone for the drive a new mirage prop, the planes, about 400hp so I will post up with mu results soon. I need to gind a old drive spacer for the damn alpha, it is impossible to find them..

therabster 09-01-2006 03:11 PM

Re: Question for you lil stinger guys
 
Are you using the old Alpha 1 Gen 1 with this engine. Also what gear ratio are you going to be using. 1.34R The original V6 would have had a 1.84R

therabster 09-01-2006 03:14 PM

Re: Question for you lil stinger guys
 

Originally Posted by therabster
Are you using the old Alpha 1 Gen 1 with this engine. Also what gear ratio are you going to be using. 1.34R The original V6 would have had a 1.84R

When do you expect to have the boat all up and running.
Keep us informed on the performance results.

Fenderjack 09-01-2006 06:51 PM

Re: Question for you lil stinger guys
 

Originally Posted by therabster
When do you expect to have the boat all up and running.
Keep us informed on the performance results.

Hopefully we will have it up and going buy mid september. I think will be running a 300 alpha drive, these drives were built at the end of the alpha production, b4 bravos for performance big blocks, so we will give it a try, I will surely post up when finished..


All times are GMT -5. The time now is 10:22 PM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.