|
Removing Grab Bars On Bolsters?
1 Attachment(s)
Is there a way to remove these without tearing apart the entire bolster?
|
Re: Removing Grab Bars On Bolsters?
On the older bolsters there's 2 access holes on the bottom. Did you check that ?
|
Re: Removing Grab Bars On Bolsters?
1 Attachment(s)
No, I didn't. What's an older bolster? Mine's a 99?
|
Re: Removing Grab Bars On Bolsters?
They look the same some what as the Bullets. Look under the back side & there s/b 2 round holes on the very bottom. If there are be carefull with the hands. Could be a little rough inside.
|
Re: Removing Grab Bars On Bolsters?
Originally Posted by cig1988
(Post 2019524)
They look the same some what as the Bullets. Look under the back side & there s/b 2 round holes on the very bottom. If there are be carefull with the hands. Could be a little rough inside.
But it begs the question, why are you taking them off?? Repainting? |
Re: Removing Grab Bars On Bolsters?
Originally Posted by lakeluvr
(Post 2019778)
A little additional info. You'll have to remove the seats from the stands. In the corners there are two holes that will probably have panels covering them. A tight fit but you can stick your arm thru them to reach the nuts on the handles.
But it begs the question, why are you taking them off?? Repainting? |
| All times are GMT -5. The time now is 04:33 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.