Depth Tranxducer
 

I have upgraded my dash to all new Livorsi/Gaffrig Guages
I have not put the new depth sounder transducer in yet the existing on Huminbird is glassed into the hull has any on replaced this or did you just cut the wires and put in a new one?

Pictures Klaw !!! We need Pictures !!

Any chance the old one will work ? Gafrig buys them from someone?

I will get picture tonight
The original was a square face huminbird and I am pretty sure the Gaffrig is a round face Huminbird the original tranducer pliug was round and new one was square so being the Pollock that I am I fit the round pulg in a square hole but it dint work.
Gafrig or Humonbird did not hasve sny sdspters so I msy hsve swsped polarity oops.

picture 1

picture 2

ooops........I want pics of the new dash !!!!!:D

where did cig put the tranducer for the depth finder,,, on a 2005 42 tiger side by side ,,,

on my tiger it is right in front of the starbord motor, similar to where klaws is. I have a new one but I'm not going to rout out the floor, I'm just going to epoxy it right to the hull a little further back under the motor.

I replaced mine. I dug it out of the hull and reglassed in the new one. Make sure you don't get air between the new transducer and the hull.

Was it hard to do? seems a little nerve racking, lol.

It wasn't to bad. Had to do it twice because I got some air between the transducer and the hull.. Opps!!!

isnt there only a certain area where you can put the tranducer,,,i dont think you can just stick it any where on the bilge floor,,,,i think it has to be a solid place in the bilge