Step pads
 

Does anyone know where I can get a set of these step pads for the rear bench seat like the ones in this picture?
I haven't had much luck finding a set in my searches!

http://i1334.photobucket.com/albums/...psgtxlzvmz.jpg

Those look like they were made from Starboard composite.

I can make them myself if need be..but I have enough projects happening right now so if I can find a set to 'plug and play' that would be nice..and I agree Griff..looks like Starboard!!

I think griff is right about those being made of starboard. When I bought my boat the previous owner gave me a slab of it to cut the steps out of so I assume he could not find pre fab replacements cause he was not afraid to spend money for the right part

PPI in Sarasota made mine.

I think I have a set.
I just looked in my shop and I cannot find my old ones, I am pretty sure they are at the upholstery shop as long as they did not toss them, which I doubt they did, you can have them as I reworked my back seat.
I will check with them a little later and let you know.

I bought 2 sets from someone on here and neither fit my 02 Gun. Send some dimensions and I will measure.

I have them in blue with red lines, and the 3' step plates (that go on the sides of the boat) to match. One of them has a crack. If you can use them let me know and I'll try to find them. I beached them in the attic. My number is 561-702-6478.

I also have the wind flaps, front spoiler, all the rails and blocks etc.

Thanks Yamaha..I would definitely appreciate it!

Quinlan..I wish I could get measurements but I am a Merchant Marine and out at sea at the moment..plus my upholstery is out of the boat and being recovered..all i can say is I have an 89 top Gun and the pads look like the ones in the picture.