![]() |
Any count on how many boats registered? Did they break 100?
|
Originally Posted by lucky strike
(Post 4690318)
So what's the story on all the debris in the water i'm reading about?
Is this going to be a factor for the run? They have been holding water back in Truman as much as they can, but it is WAY full now and they are dumping into LOTO. They were holding back water to reduce flows to the Osage River which is already high and that eventually dumps into the flooded Missouri River. LOTO was never meant for flood control. Its just a pass through lake from Truman to the Osage River. LOTO get lowered about 5-6 ' over the winter in prep for Spring thaw and rain then its pretty steady around 659'. LOTO is near full pool now close to 660' and dumping about the same amount of water into the Osage River as Truman is dumping into LOTO. Both Truman and the Osage River area are basically flooded and the Osage River is going to get worse for sure and residents have been warned. The big question......Rain......If LOTO gets hit with a couple inches of rain, the lake will most likely go to 662' which will cause some flooding at LOTO to lower homes at lower elevations. It will also cause even more debris to wash off the shore banks and float into the lake. The short answer is still..............maybe, but it will still be great event. |
Thank you Griff.... It's a long haul from South Florida with 2 boats.
Hope everything straightens out for the run. We will be there! |
Originally Posted by lucky strike
(Post 4690598)
Thank you Griff.... It's a long haul from South Florida with 2 boats.
Hope everything straightens out for the run. We will be there! If it's any consolation I'll forward y'all the same generosity I was shown in KW, you don't buy any drinks as long as I'm around. https://www.offshoreonly.com/forums/...aehrung004.gif |
|
Originally Posted by payuppsucker
(Post 4690629)
|
Originally Posted by payuppsucker
(Post 4690629)
|
Nice Kelly! Lot of motor sitting on $4 engine stands!!! Dyno numbers, or is that a secret? |
1047 and 1051 at 6000 on the HP. He said one blower was a little stronger than the other. Don't have the dyno sheets here and I can't remember what the torque was but I think he said mid 900s.
|
And Tank before you say anything, I'm eating a cheeseburger............not jacking around on OSO.
|
| All times are GMT -5. The time now is 11:32 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.