21 Cigarette
 

I just picked one up and was wondering how many were made and what years did they start and stop??
Thanks
Brett

Do a search here on OSO. I remember a thread talking about these hulls. If I'm not mistaken Craig Barrie was involved in the conversation. They didn't make many, 11 or 12 perhaps. Nice, rare boat- can you post some pics?
Good luck with it.
Matt

Is it a 20' ?

i was wondering the same thing. these boats pre-date where you can tell year and length (at least what manufacturer said was length) from the hull id number. somebody hangs a platform on a 20 and somebody else says it is a 21. guy with boat next to me (37 or 38 silverton) calls it a 43 cuz of platform and pulpit.

I worked at cigarette with Don in the early 70S. the 20' cigarette was molded from a 19' glastron, and we pushed the sides out to widen the hull then built that deck with the water ski box in front of the windshield . two buckets in front and a bench in the rear. Chris craft v8 chevy with volvo drive. a few we installed Harden Marine v8s with a berkley water jet. not sure I think , less than 25 units built total. 60 miles an hour maybe . Knocky House and my self rigged most of these along with the 28 open style cigarette.later we made the 28 ss deck also. sonny miller

If your serious, PM Cig20 on the site. He had one for sale a while back. He is very knowledgeable on them. I believe he owned 2 of them over the years...

Check out this tread on the board. is that the one with the 200 Merchttp://www.offshoreonly.com/forums/general-boating-discussion/85575-21-cigarette.html

That's mine! I found it in a beat down house at loto sitting in a dirt floor barn. Who's boat is that when the pics were taking??? And what year was the pics taking?
Brett

Look at J-Bonz post that's the one I got
Thanks
Brett

Pics were taken on 11/14/2011

I designed the 21' at the same time that I did the Bullet and the Decathlon. We we expecting a recession, and looked for cheaper products. Turned out that our big boat sales got better, and we didn't have lamination space for the little ones. Just quit offering them.

what power did it come with mine has a 200hp black hawk merc.
Thanks
Brett

The molds for the MINI'S are here in Havasu they are 13'.

Here's the one's that are going to be made here in havasu VERY SOON. And bigger motor on them.:whistle:
http://youtu.be/AfK91axfMU8

Ahh, the Mini Hawk. I've got one of those.....about to trade mine in for a SBC.

Any photos of SBC?