My magnum was a similar hull but lighter-high rev 280 small blocks would turn 5k with 23s. Back in the days of working at a dealer rigging wellcrafts, all the scarab panthers received 23s with the 454 mag and 21s with the 330s. That was through bravo dirves. You are spinning small blocks through transmissions and trs drives. Bullet proof package but not efficient. If memory serves me you loose about 18 percent of your power going though the trans and trs. Your WOT target should be 4700 with light load. This would give you your most efficient cruise speed at 3400. 21 Mirage should put you there.
|
Is there anything to be gained by spinning the motors at a higher RPM than 4700 under load? Obviously the inherent risk of blowing something up, but if the blocks were built to handle say 6000 RPM for sustained runs, is it advantageous or just a waste of fuel.
I'm sure these questions seem rudimentary, but I do appreciate the time yall are taking to answer. |
Generally HP/torque figures rise as RPMs rise. If you can let them spin a little faster, you get into more HP/torque. The hope is the gain in HPTQ will allow the prop to spin faster than the pitch difference, and you gain speed and efficiency, along with acceleration and better "boatability". Example: say you drop two pitches and mechanically that should net you 2-300 RPM. But, because you gained another 30hp, you pick up 600 Rpm. It's a fine line, but you have to remember......NOTHING touches the water to transfer energy but the prop. I see people have props as an afterthought. They will spend $5000 to get 3 mph, when a couple hours at a prop shop with a cupping hammer would have the same result. We used to cup our racing props on the trailer ball!!!! Lab that Mercury! LOL!
So spend some time with them and get them where you want them. Makes a world of difference. |
Getting the props I have reworked is on the To-Do list, I will get some pics posted up here in just a few, they are pretty bad as far as edge contour goes. I have called a couple of the local boat places but none of them seem to want to touch props.
|
Call BBlades.
|
Are you Stephenville Texas? If yes, call B&B Propeller Service in Ft.Worth.
|
Ok, I'll give them a call in the morning , thanks CD
|
Originally Posted by TruxtonFox
(Post 4468418)
I wish you woulda posted that about 4 hours ago, I just gave a guy my word Id spend 500 on his props, same as yours. Thanks for the offer though!
|
All times are GMT -5. The time now is 06:24 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.