Offshoreonly.com - Hey dave , ever installed steps on conv v bottom ?

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- Detailing, Painting, & Fiberglass (https://www.offshoreonly.com/forums/detailing-painting-fiberglass-167/)

- - Hey dave , ever installed steps on conv v bottom ? (https://www.offshoreonly.com/forums/detailing-painting-fiberglass/296656-hey-dave-ever-installed-steps-conv-v-bottom.html)

That's right I'm sorry.

Its all good !! I may have to break open piggy bank for bottom re-design !!! He said 90 + with 632 - 800 hp .

Quote:

Originally Posted by Sydwayz (Post 3937403)

What method are you going to use to determine the performance dynamics and turning capabilities of the hull at different speeds with the new steps?
Are you going to adjust the lifting strakes as well?
How tall are you going to make them?
Will you be adjusting the transom angle as well to compensate for the new angle of attack?
Why 2 steps as opposed to 1 or 3 or 4?

Transom angle? One would assume that this can be addressed with the old tilt and trim button. Or does it need be solved in the same method as the federal government. Over complicated with 10000 pages of procedures.