Help!! new transom and bulkhead got wet
 

Going crazy here! I finished up sealing my new transom and bulkhead with 1.5oz csm and vinyl ester and everything looked great. It was drying slow so I didn't get the second side done until late so I figured instead of screwing it up by trying to move it I'll just leave it alone. My problem now is the weather that was supposed to be clear with 0% chance of rain decided to change. Now my new pieces are rain wet and uncured. I got them covered now but there already wet. What do I do now? Are they salvageable? will the resin cure properly? Or do I have a $400 chunk of fire wood that I can't even burn. Please help I'm going crazy trying to figure out what to do.

the glass is fine. lay wood untreaded side up in the sun to dry out.

It will be fine just make sure its dry before u get to glassing again.

yep, get some sun on it and cook it for a bit. I had two rolls of a very expensive S glass get soaked and it was fine. it was a stiff 22 inch wide 24 oz bi ax and I put It in big un rolled coils out in my parking lot in the sun.

Thanks guys that's a relief I thought all that time and money was gone. I did lay it all out in the sun and the resin cleared up and hardened but I did get a few small areas that have little air bubbles but no water under the mat so I guess I'm good.