Started making my trim tabs today!
#1
Registered
Thread Starter
Join Date: Sep 2007
Location: Deltona, Florida
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
Started making my trim tabs today!
so here are all the pics enjoy, post comments questions and criticisms.
Its not finished yet, im going to have them powder coated when im done
i still have to finish welding it, dinner was done so i rushed out of the shop
I dont have the hinge on there yet cuz i have to order them from mcmaster.
Its not finished yet, im going to have them powder coated when im done
i still have to finish welding it, dinner was done so i rushed out of the shop
I dont have the hinge on there yet cuz i have to order them from mcmaster.
#7
Registered
Thread Starter
Join Date: Sep 2007
Location: Deltona, Florida
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
Got the other one made and the hinges on today, called about getting a wholesale account at the place im going to get my actuators at, and that is all taken care of, so hopefully in a week or two ill have the rams and get the upper mounts made and get these bad boys on the boat!... ohh and ofcoarse have them powdercoated black.
#9
Registered
Thread Starter
Join Date: Sep 2007
Location: Deltona, Florida
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
Going to go with electric, cheaper and slightly easier to install, the rams are from Lectrotab same ones in the pic im about to post, as well the tabs i made are based off this design, going to test them out when i get them on the boat and see if they bend.. if they do ohh well it dosnt take long to make these things if i had to remake/alter them.