rubber for the swimplatforms
 

I have a factory baja swim platform, and I wanna get it powdercoated this winter, but I have to remove the rubber that like on top, the non slip stuff. Anyone know where I can get new stuff at? ITs like a push in kind. It just pushes into a grove in the platform itself to hold it tight..

give baja a call...

I would go to a local powder coat company. They should be able to sand blast it and powder coat it. Check out the Illusion Powder Coats by Dupont. They sparkle and change colors in the sunlight. I'm getting one delivered tomorrow. Can't wait.

I know exactly what you are talking about and I know some people who had a very hard time finding what you are talking about.... and that was when there still was a Baja company. I would post in the Baja section and hopefully somebody can point you in the right direction.
Baja did not make there own swim platforms. I think they were made by Extreme Marine. Maybe check with them also.

There is no more Baja

Did Reggie pull the plug ?? just saw a ad for a new one this week ??

Fixx
 

They still doing business,,Phone: (252) 975-2000

There is still Baja by Fountain on a very limited basis, but I highly doubt anyone at Fountain would even know what he is talking about. Baja only used that style platform for a couple years.

ok..well still looking?? Anyone know where I can get it at?

Maybe Brett at Perf Boat Brokerage might know. He was Baja dealer before he went PBB.

ok ill have to call him. I checked that extreem marine, but they dont have the things im looking for. I have the rubber on my platform. I dont just have the grip tape..

i put some 3m black grip tape on my platform ands its held up threw the years try looking at 3m products

my platform has like groves where the rubber sits down in the groves, and it like sits alittle above the bars itself. So its like cushions the feet. So Im worried if that I dont reinstall the rubber it will be really hurtfull to step on the platform.

Try SB Group They make or can make any type of extruded rubber. I would call extreme marine and find out who supplied them with the rubber. It always seems to shrink and needs replaced.

Check with X-T Innovator ( Dave ) on the baja thread.