Offshoreonly.com

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   Do It Yourself, Boating on a Budget (https://www.offshoreonly.com/forums/do-yourself-boating-budget-249/)
-   -   6.2L stalling at idle. Ideas? (https://www.offshoreonly.com/forums/do-yourself-boating-budget/275964-6-2l-stalling-idle-ideas.html)

Captain YARRR 05-07-2012 12:41 PM

6.2L stalling at idle. Ideas?
 
Idling out of the marina yesterday, one engine cut out and would crank but wouldn't turn over. So I slowly cruised out to the cove on one engine.

Let it chill for about 20 minutes and she turned over. Runs like crazy once she's under throttle, no difference between it and the port engine.

When she idles, she has a slight miss. I think I am going to change the spark plugs, who knows when that was last done. Just got the boat in November with ~150 hours.

I have a spare cap and rotor at home. Ordering a fuel filter too. Anything else I should be doing before next weekend?

Just had my throttle cables replaced, could this just be a screwed up install?

Knot 4 Me 05-07-2012 01:23 PM

If it runs fine off idle but does not want to idle it is most likely the IAC valve.

Expensive Date 05-07-2012 01:54 PM


Originally Posted by knot 4 me (Post 3681468)
if it runs fine off idle but does not want to idle it is most likely the iac valve.

+ 1 million

Griff 05-07-2012 02:47 PM

Yep, IAC is bad.

Captain YARRR 05-07-2012 05:37 PM

Thanks guys...sounds pretty clean cut. Do you guys happen to know the part number?

Expensive Date 05-07-2012 06:07 PM


Originally Posted by Captain YARRR (Post 3681727)
Thanks guys...sounds pretty clean cut. Do you guys happen to know the part number?

www.mercruiserparts.com Type in your engine and serial number, it will take you to a break down. You can also use a car one if you do a search on here I think it was mentioned in a thread. and buy two so you have one when the other one goes.

Captain YARRR 05-07-2012 08:18 PM

Thanks so much. I think I found the thread:

http://www.offshoreonly.com/forums/d...iac-motor.html

Griswald 05-07-2012 08:23 PM

Make sure the pintle looks exactly like the one you take off

Ted G 05-07-2012 08:27 PM

Compare prices, last time I found a car one it was almost exactly what BAM gets for them.

bigboat28 05-07-2012 09:01 PM

Also I was told if you take the little foam piece out on the new one they will not go bad. I was told that filter causes the problem. I took both out when I replaced my two.


All times are GMT -5. The time now is 02:29 AM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.