![]() |
Adding more engine vents
Ok, since I've had some issues with heat affecting my ignition components I have been thinking of adding two more engine vents to my boat. I currently have two vents, one on each side of my boat. I was thinking of adding two on the rear to promote engine bay ventilation.
Thoughts? |
Just make sure a sudden slow down does not swamp your boat if you're thinking of adding vents to the back.
|
I have a decent molded in swim platform. I was going to add the vents as high as possible on the stern to prevent water intrusion.
Thanks |
anything to get the hot air out and cooler in is a + I have read TSB's from engine manufacture's regaurding not enough air flow to supply the engine(s) to run properly...
|
I have a 260hp 350 and I only have two 15.5x2 inch engine vents. I'm going to order two more and add them to the stern, at the top of my swim platform.
|
the only thing i have to say is that the vents on the back suck in water spray so i would try to put them somewhere else. Im trying to address this right now too. One person said that your supposed to run scat tubing from the vents on the back to the bilge. I dunno
|
Originally Posted by Jonesyfxr
(Post 4186717)
I have a 260hp 350 and I only have two 15.5x2 inch engine vents.
But, I have a lot of air space between rear seat and side of the boat..on both sides. Question - is it engine compartment heat or electronic heat that's the issue ? |
Speaking of engine vents how do you keep paint on those things? I bought some new ones and they flaked off too even in fresh water.
|
Originally Posted by SB
(Post 4186736)
That's all I have too. Approx 350-375hp small block. I run the snot out of it and sometimes for long times. No problems.
But, I have a lot of air space between rear seat and side of the boat..on both sides. Question - is it engine compartment heat or electronic heat that's the issue ? |
|
I think I will try to place the vents using the strip line as the center of the vent. I will also align the vents with the stern rail. I like symmetry and whenever I install something I try to make it look original, not like an after thought.
|
| All times are GMT -5. The time now is 03:05 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.