502 Exhaust Manifolds and Risers time
It's time for new manifolds and risers on my Cobalt and I'm thinking of going aftermarket. I'm new to the forum so I'm hoping this is in the right section. Does anybody have any experience with this setup?
http://www.cpperformance.com/p-73943...er-system.aspx Is it as simple as taking the old manifolds and risers off and putting this set of exhaust in it's place? The cost is a bit high but if it means a little more power and a little less emissions stuff, I think I'm interested. Just need to know what the complexity of the install might be. Any feedback is greatly appreciated. If not this system, any others that are recommended? Seems like I'm looking at $1500 - $2000 to replace the stock with OEM stuff. |
I would look at the others ,if u r not going to step up the hp ....hardin /gills,,,seaward stuff. Cp is a good place to get just abt any style // i too looking at another set ....and leaning toward the h.p gill ones from cp
|
I went with Stainless Marine last year on my 502 and have been very pleased.
|
Originally Posted by Bgibson5
(Post 4503473)
I went with Stainless Marine last year on my 502 and have been very pleased.
|
If you have catalysis exhaust, I'm not so sure you can go after market, without having something done with the PCM
|
Originally Posted by AllDodge
(Post 4503560)
If you have catalysis exhaust, I'm not so sure you can go after market, without having something done with the PCM
So, now I just need to find an exhaust system that fits the 8.2L Mag EC motor that has O2 sensor ports. That is the sticking point. |
OK got it, this is the same issue as bypassing the diesel setups. They do make a 3600 set at cpperformance and has the bung installed for the O2 sensor
|
I would not let the absence of bungs be a major factor. Most risers can be modified to accept O2's. Contact Eddie at Young Performance he does a great job at a fair price and is very reputable (and nice) guy. That's what I did with my S/M setup.
|
Originally Posted by GLENAMY 242SS
(Post 4503579)
I would not let the absence of bungs be a major factor. Most risers can be modified to accept O2's. Contact Eddie at Young Performance he does a great job at a fair price and is very reputable (and nice) guy. That's what I did with my S/M setup.
|
He did a lot more to mine than just the bungs so I can't say. I can say either is a good choice for quality.
|
All times are GMT -5. The time now is 09:12 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.