Bravo XR Shift Cable Adjustment Tools
 

Starboard shift cable, from drive to on engine acutuator, had a kink near the business end in it since I have owned the boat. It was straightened out but after a few r and r of the drives and a missed correct cable install by me the cable has a kink and needs replaced. Can someone confirm the tool part #s I need. There are 2 one for the ball end and on for the actuator side. So far I have found 91-12427T Merc or 18-9807 Sierra equivalent but cannot find the 2nd tool #. Any help would be appreciated.

just buy these part number is on label 18- 9810 Sierra they are fine. I have them about 10 - here is a pics of what I have., ebay amazon like 35 to 50 bucks for the kit.https://cimg0.ibsrv.net/gimg/www.off...c67b9cf1c5.jpg

just buy these part number is on label 18- 9810 Sierra they are fine. I have them about 10 - here is a pics of what I have., ebay amazon like 35 to 50 bucks for the kit.https://cimg0.ibsrv.net/gimg/www.off...c67b9cf1c5.jpg

If any interest shipped 50 bucks to the door for whomever.

And if one is changing the shift cable buy the Merc one in kit form. . The bellows is better as well than the aftermarkets

Thanks guys for info.

its both tools one part number -- one kit.

I have all the tools and last time I replaced one, I didn't use any of them. The new cable came pre-pinned (adjusted to correct length). All I did was make sure I had 3 inch pin to pin on the shift plate, installed and it work perfect.