|
22ft. Donzi help
Customer just picked up a 22, think its a 88-91 year, used to have Arneson drive so we had the transom rebuilt. We are getting ready to cut hole for Bravo, what is the proper "x" dem. or measurement, from bottom of V to center line of tool/crankshaft. Any help would be great, im sure there lots of opions.
|
Originally Posted by marinetrans
(Post 3858857)
Customer just picked up a 22, think its a 88-91 year, used to have Arneson drive so we had the transom rebuilt. We are getting ready to cut hole for Bravo, what is the proper "x" dem. or measurement, from bottom of V to center line of tool/crankshaft. Any help would be great, im sure there lots of opions.
They varied over the years. head to donzi.net for more help specific to this. If it were me I'd go with the '87 X. it's a bit over an inch higher than the regular X and the boat runs much better like that. Donzi did the same thing on the Shelby and picked up speed. |
Ahhh, Kens old boat shows up! Nice project.
Most of them were setup at 14". |
Its real nice,Ken did a good job. Thanks for info guys.
|
| All times are GMT -5. The time now is 07:31 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.