Lower units with nosecone XR
 

Hi guys

Have a XR 1,50:1. Since my v-hull 28 Arrow prob are a +100mph boat I can use a nose cone. Is it possible to get a new empty housing with nose cone and just move over the gear set from the housing without nose cone? I dont like that "Glue your nose cone self"-kits.

Any idea?

Thanks for your advices.


Mange

Purchase a Merc XR Sportmaster lower housing it has a nose cone, also has a low water pickup in the bottom of the cone. This housing is stronger than standard XR. Move your existing shafts,bearings,gears, etc to new housing. You must reshim to Merc. specs! Any Merc vender or maybe an OSO member can sell you one. There are professional drive builders on OSO that can help you.

You don´t already have one ?
Guess I´m not the only one with empty pockets...
Here Mange...why didn´t you ask me first ? :ernaehrung004:
The lower only case, which is far better than a Sportmaster lower, is on Sale for just under 2K.
*the grey Speedster24 has a 2inch shorter one which needs shorter axles ,naturally.
http://www.imcomarine.com/pages/sterndrives.html

Mika,
Its more a question of time actually. And I dont wana buy things who dont work on my boat.

Boater 8987, thanks for your help. Sounds like a great idea, just what I asked about. Do you have any idea were to buy this housing?


Thanks
Mange

There is someone selling a complete imco lower on here for uner $3000. It is assmebled and has the 1 1/4" propshaft. It is a 2" shorty though. Look in the classifieds or on the swap shop when it gets back. I think this is the same guy.
http://cgi.ebay.com/ebaymotors/IMCO-...QQcmdZViewItem

320es is it the newer design?

If yes I think Mange should consider it.

You can go to the classified ad section. Do an advanced search under lower units and drives, key word
Sportmaster. Make sure it is an XR version not an outboard. They come in standard length and 2" shorty. There are many merc venders in this area that can sell you one or a vender will read your thread and pm you.

Or you can buy an IMCO stock length lower gearcase without the internals and have your own internals installed. The IMCO gearcase has their nose cone molded right into the casting design.

I have a case with nose cone and low water pick up, standard length. 585-233-2108. Its just laying around. XR upper case as well.