![]() |
bravo 1 drive play
My drives are off was checking the gimbal ring for play i have a tad bit of play in the bottom pin on the gimbal ring and i have 1/6" side play on both helmets inside the ring but no up and down play,any thing i should do.
Thanks |
Tighten those two nuts at the top of the gimbal facing aft. Do it every season.
|
Thanks
|
the right way is to loosen them and then torque evenly to
53lbs |
Originally Posted by rssteiny
(Post 3064114)
My drives are off was checking the gimbal ring for play i have a tad bit of play in the bottom pin on the gimbal ring and i have 1/6" side play on both helmets inside the ring but no up and down play,any thing i should do.
Thanks |
Originally Posted by 1BIGJIM
(Post 3064656)
You can remove the lower swivel shaft by removing the cotter key. The shaft is probably worn out. It also has a bushing that can also be worn out. I can post some pictures if you like.
Thanks |
| All times are GMT -5. The time now is 06:09 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.