are this headers any good?
 

i got a good deal on this headers i dont know if i should pull the trigger on the deal what you guys think? they are for a 454 bbc

:readinghelp:

http://i21.photobucket.com/albums/b2...x/IMG_1105.jpg
http://i21.photobucket.com/albums/b2...x/IMG_1106.jpg

how much for them jim?

They look home built and set up for a V drive or jet boat. Also they are not set up for a wet pipe as far as I can tell. Not much $ I hope.

Wannabe

The guy asked 500$ but am low balling him for 350$

They are water jacketed

Those things are not headers and will not allow for any growth in horsepower . Looks like power robbers to me . Those are home made log exhaust . You asked what i think , RUN ! These are headers .

http://i1243.photobucket.com/albums/.../headers-3.jpg

No, :bong:

So better off staying with my old logs then?

http://i1243.photobucket.com/albums/...ep/rockout.gif http://i1243.photobucket.com/albums/...ep/roflmao.gif

If we had a better idea what your doing you would get a better answer .

After taking a closer look i would not trust them .

I have a jaws 24 with a 454 am looking into mild upgrades

Looking for a cam,carb and intake manifold any recomendations?

Im in with the Deep, no offense but they look like they were made from the Tin man

For a cam there is only one place to look . Contact Bob Madara at 585-654-8583 or drop him an e-mail at [email protected]

What carb should I run? Holley 750 or. 800?

Don't listen to this jack off . Anyway either one would work just watch your jetting . There is a formula to figure cfm but i don't remember it . Bob Madara could help you with this too . You would have gotten more answers had you put this question in the proper section . This has nothing to do with out-drives .

Thanks , I know I must of made a mistake when I clicked to start the thread.

I have a set of Hardin marine flagship dry exhaust , recently
Pressure tested will sell cheap . Pm me if interested