Sharp Ride. Look forward to the reports on the X Drives.
You will have many Hours of enjoyment.
First Ones I have seen in Use.:drool1::bestwishes:
Dare to ask Cost of Per Unit?$$

Those buggers look big hanging off those gimbles .

They look real serious. Let us know how they do.

down to the last part. had to cut the tie bar down and re-tap the thread. One thing we can't do ourselves. The weather is looking like being beautiful this weekend and I am kicking myself because I don't think I can get the bar done in time.

Just curious, what size tie-bar are you going to use? Sounds as if you will be using the one you already had, correct? Thanks!

Yes, using the same one. It is about 1 1/2. It's being shortened and retapped because the mounts are now on the side of the drives and not the top. All the chunky IMCO steering mounts are now gone and the rams connect on the other side of the drives. Looks very neat.

Nice Set up!

Aus,

I'm going through a similar re-rig and have been told by more than one knowledgeable person that I need to go to a 1 3/4" tie-bar at absolute minimum. There is a ton of stress on the drives with the #6 surface props and the bar will flex a LOT.....to the point it causes handling problems. Extension boxes amplify the problem. There's a guy on here that has this setup on a cat and not only went to the 1 3/4" bar, he also left his smaller bar on as well. I guess there is a reason #6 drives come with a 2 1/2" + tie-bar.

I'm far from an expert, but you might want to check into it to be safe. I'm also not that familiar with the X-Power drive, so it may not be an issue with them. Good luck with your project!

I've yet to hear what type of shifting mechanism/clutch-trans.
these things have.....anyone know yet ?

so what is the cost minus shipping of course?