Shortening skeg 1"
#1
Registered
Thread Starter
Shortening skeg 1"
Should I?
The SCX-4 skeg extends 1" deeper into the water than my old -1 Bravo lowers.
Others have put -2 Bravo lowers on the same boat with no problems.
I read an article where Warby took 1" off the rudder and gained speed and handling.....of course, that's at 400 mph!
The SCX-4 skeg extends 1" deeper into the water than my old -1 Bravo lowers.
Others have put -2 Bravo lowers on the same boat with no problems.
I read an article where Warby took 1" off the rudder and gained speed and handling.....of course, that's at 400 mph!
#4
Registered
We have 2 inch spacers in there now which I believe it brings it back to propshaft about an inch above the bottom he said it handles great but waiting for better weather to try 2 more sets of props, trying to get the ass end of the boat up he says the 18 degree props are too much . we might go back to the one inch spacer to see if the prop blowout comes back , Eddie also did ALLOT of shaping to the lowers .
#6
Registered
#10
Registered
were still bouncing around 115 but dealing with 20+ prop slip and previous prop blowout issues and still havnt had a chance to wring it out . have you tried 6 blades yet?