trim height question
 

was hoping someone could help with a suggestion on my trim height . had to replace trim senders and need an idea of distance to set full up on throttle trim switch. inches from ram bolt to ram bolt. it for my 08 donzi zr27, it does have twin steps in the hull , can get any other measurement needed thanks

The Stock Bravo Drive Trim Limit Dimension is 21-3/4 in.

thank you,,Good starting place.

We adjusted it based on a different measurement as found here...

http://www.mercstuff.com/trim_limit.htm

hopefully there is no difference in the measurements.

Anyone have any knowledge on this?

Interesting, looks like someone took the time to come up with a different measurement area is all. While the measurement of 6-1/2" might be right for some drive models it may or may not be right for other drive models I could only assume.

Using those instructions, I would question if they are referencing their adjustment height to an R/MR/ALPHA ONE/Alpha One Gen 2/Bravo drive, etc. etc. as they have different trim adjustment heights which is typically measured from front anchor point to rear anchor point centerlines.

The instructions didn't seem to clarify/reference what drive model they were setting up/adjusting.