Looking for Bravo 1 tools
 

I recently had one of my outdrive cone clutch assemblies go bad. So I manufactured a outdrive jack and stand so I could remove and reinstall the outdrive by myself. Ordered the clutch and gear set only to find out there is a special tool for removing the bearing inner races from the top cover and from down inside the drive housing itself. Does anyone know where I can purchase the puller and installation tool?

Any mercury dealer can sell you the tools order the manual and it gives you the part numbers for the tools you need.

If you give me part numbers and scripts of the tools I can see what I have doubles of at cheaper cost than new plus can sell you new tools on top of.

I would have to double check for anything that I might have doubles on because some stuff already sold but I still have a lot of marine tools.

I also have a bunch of OEM service manuals if needed. Everything is in storage so I would need a 1 or 2 day advance notice to check on what is needed here .

BUP Sounds good. The instructions that have the part #s that came with the parts are at the shop. I will PM you Thanks Mark

BUP: Here are P/Ns

91-90244A1- Puller jaws, puller guide, driver guide and bolt. All one tool.

91-90774- Puller guide

Thanks

I do have these and even brand new. I found this on Ebay NOT MINE but I can sell you this for 50 bucks brand new but let me check on the price for 91-90244A1 thru Merc tomorrow and then give you a total with shipping.

I am keeping my used sets in my tool box and will sell the brand new sets if you want them. My guess and only guess at this time around 300 bucks shipped to your door for both tools sets you want and again brand new not used.

Here is ebay, A rusted up item for 50 bucks.

. http://www.ebay.com/itm/MERCURY-MERC...-/191393583447