|
Be sure to install new starters, new bilge bumps, and triple check anything on the bottom of the engines: bolts, nuts, connections, clamps, etc.
I had my AT for almost 14 years and never had to pull the engines. But one time I did find an oil pan bolt in the bilge, and it was a real bear to find where it came from, and reinstalling it was a 1/2 case of beer in itself.. |
Get on eBay for the install and alighnment tools, a member here make them to merc spec and sells them on eBay
under the name whoya2350. The whole driver and alighnment to is $110 https://www.ebay.com/itm/Alignment-Tool-Gimbal-Bearing-Seal-Bellow-Tool-Set-Mercruiser-91-805475A1-OMC/282420031118?ssPageName=STRK%3AMEBIDX%3AIT&_trksid =p2060353.m1438.l2649 You can also look up Frisco boater on youtube he has a good instructional video on changing the bellows and gimble bearing. |
Originally Posted by Mohavvalley
(Post 4629728)
Get on eBay for the install and alighnment tools, a member here make them to merc spec and sells them on eBay
under the name whoya2350. The whole driver and alighnment to is $110 .com/itm/Alignment-Tool-Gimbal-Bearing-Seal-Bellow-Tool-Set-Mercruiser-91-805475A1-OMC/282420031118?ssPageName=STRK%3AMEBIDX%3AIT&_trksid =p2060353.m1438.l2649 You can also look up Frisco boater on youtube he has a good instructional video on changing the bellows and gimble bearing. this is a must, your going to need this this is a must..your going to need this |
| All times are GMT -5. The time now is 02:35 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.