The 525EFI gen2 and 600/700SCi with the connectors have the Interface build in in the main ECM. You need only the wire and the senders.

https://cimg3.ibsrv.net/gimg/www.off...1271062b57.jpg
https://cimg1.ibsrv.net/gimg/www.off...4388dd9cb0.jpg
https://cimg1.ibsrv.net/gimg/www.off...6367e107ba.jpg
https://cimg8.ibsrv.net/gimg/www.off...badd9eb209.jpg

I test the engine conector with the digital trim sender wires. I conect the digital trim sender wire on my 525efi trim tab conector. If i trim my drive, the smartcarft shows me the tabs are moving. So i ordert the original trim tab senders. I messured the right place on some new 380S Tabs and installed them on my old 380S. I used a PPE fitting and heated it up for the right tread. I make my own T-wire from the engine conector to the 2 trim tabs. purple + , black/orange - , green orange Tab, green ? Tab other side. works fine.

hier are some pictures from what i found to conect the tabs if the engine have no cenection.
https://cimg9.ibsrv.net/gimg/www.off...bdc8b79914.jpg
https://cimg0.ibsrv.net/gimg/www.off...857bc98a0a.jpg
https://cimg1.ibsrv.net/gimg/www.off...5e30cae81d.jpg
https://cimg2.ibsrv.net/gimg/www.off...6691f04382.jpg
https://cimg3.ibsrv.net/gimg/www.off...d15b5bbac7.jpg
https://cimg7.ibsrv.net/gimg/www.off...856e610919.jpg
https://cimg8.ibsrv.net/gimg/www.off...826ab3b1d8.jpg
https://cimg1.ibsrv.net/gimg/www.off...b75c49c0f6.jpg
https://cimg3.ibsrv.net/gimg/www.off...95f53f3268.jpg
https://cimg8.ibsrv.net/gimg/www.off...a16ee32e0.jpeg