|
https://cimg1.ibsrv.net/gimg/www.off...7b2a36a3c.jpeg
Originally Posted by Petrocanada
(Post 4733820)
That is great, was it buried down far behind?
Is it the only 3 wire connector back there? Would you happen to have pictures Thanks Lil Mick in advance the picture is in this thread. |
Originally Posted by Lil Mick
(Post 4733831)
https://cimg1.ibsrv.net/gimg/www.off...7b2a36a3c.jpeg
mine was on a 525. It was not buried it was next to where the harness plug is located for the data cable. the picture is in this thread. ok I’ll look harder when I’m at the boat this weekend |
|
Lil Mick thanks for posting this. I found it in my searches, 2 years later after you posted it.
I also have a non- smart craft equipped (Year: 2005) 525, and the Vessel View Mobile would not power up. I located the 3-wire plugs which were attached to the main harness, removed the blank caps, and plugged them into each other. Problem solved. I couldn’t find this info anywhere else, so thank you for posting and I hope this helps someone else down the line. |
Do all Of the engine wiring have the 3 wire connector to open the power for on of the engines.
I have searched my harness and cannot find it only the two in the last picture. I have dual engine setup and and running two cable two a 5 port j box then a gateway to get it to my nema 200 network then my simrad go9 se. I have already changed the city id. |
I don’t have the 3 wire connectors on my 525efi gen2.
i cut the 3 wires in the blue SmartCraft cable from engine to the j-box on the BB engine. so the StB Engine Powers the SmartCraft network. |
cant post pics yet
|
11
|
22
|
| All times are GMT -5. The time now is 08:16 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.