ambient temp sensor intergration
I have vessel view race edition with the mercury ambient temp sensor drilled into the fiberglass, upgrading to a simrad display with the vessel view link and N2K network. had anybody done this and found a way to use the mercury ambient sensor? sensor is part number 889575 and has a 2 terminal connector, I called mercury 3 times and 2 tech guys said there is no way to integrate the old sensor into the new network and to buy a sensor that plugs right into the N2K network, and 1 tech guy said to purchase two vessel view 4 harnesses part number 8M0075065 and 8M0075066 and it will plug in. does anybody have any insight to this? (or these harnesses laying around they want to sell cheap)
thanks |
yes i have used the Sensor from my VesselView7 on my VesselviewLnik Module.
The new Vesselview Link Module have only 1 Wire with no conection to Temps Sensore ore System Link ( To AGI Module....) The Module are the same like the Vesselview4 Display, only without the display. I order the https://cimg6.ibsrv.net/gimg/www.off...7faa750775.jpg https://cimg8.ibsrv.net/gimg/www.off...17ac58a108.jpg Works nice. i have see it in the Smartcraft Network Book. https://cimg3.ibsrv.net/gimg/www.off...d5935395db.jpg https://cimg4.ibsrv.net/gimg/www.off...6a31e84dc1.jpg |
yup it works, throw away the harnesses that come with the link kit and order the ones listed above... good to go
|
The harnes have 4 Link Ports for gauges ore AGI and a wire set for the audio warning buzzer too.
|
All times are GMT -5. The time now is 06:51 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.