Bottom Blueprinting
I would love to get some advise from you guys. I'm getting ready to go ahead and flip the boat on it's side and do one side at a time. I wasn't planning on doing it, but I figure there is no better time then now since I have the motors out, drive off and fuel tank empty.
My plan in to cut down the high spot's till I hit resin, then fill the low's. What do you guys like to use for filler? I was thinking about Marglass or Duraglass. Then I'm just going to sharpen where the bottom meets the transom, and sharpen/straighten the strakes, then gel that side and flip it over and do the same thing on the other side. I'm planing on using Gel with Duratec and spraying with a gravity gun. How many coats would you lay down? I was thinking 4. Thanks for the input fella's! Frank |
see my post . . . . uhmmm . . . . shhhh . . . the other thread you started . . . uh . . . (elsewhere) :party-smiley-004:
alll your questions are answered . . . actually i just didnt feel like re typing it :D call me if ya need tips or anything Frank |
Originally Posted by glassdave
(Post 2814290)
see my post . . . . uhmmm . . . . shhhh . . . the other thread you started . . . uh . . . (elsewhere) :party-smiley-004:
alll your questions are answered . . . actually i just didnt feel like re typing it :D call me if ya need tips or anything Frank Thanks Dave! I'm sure the tech hotline will be ringing soon:ernaehrung004: |
He should be alright . . . its not like it's one of those floppy old Aerotek's or something . . . :D
|
I know, i just figured it was "bust on DD week" :p
Yes lay'in upside down is a total PIA . . . . |
Thanks Dave! I'm sure the tech hotline will be ringing soon
So theres a Glassdave hotline :eek::ernaehrung004: |
apparently so, an its open 24/7 . . . . :drink:
|
Originally Posted by glassdave
(Post 2814699)
apparently so, an its open 24/7 . . . . :drink:
|
All times are GMT -5. The time now is 01:55 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.