Help GlassDave!
#1
Registered
Thread Starter
Help GlassDave!
Before paint we wanted to at least mock up the new power and tube headers. With the straight tails we need to cut new holes inside and a bit higher than where they currently are. In doing so, we will need to cut through two "supports" that run vertically on the inside of the transom just outside of the inner transome plate. It is maybe 3/4 wide, comes out an inch or so, and comes up from the bottom of the bulge to the bottom of the "tail". It does not seem to be a problem but wanted to pass it by you.
I cannot figure out how to post a pic from my phone, but could text it to you. My cell is 319-360-7140
THANKS a bunch!
I cannot figure out how to post a pic from my phone, but could text it to you. My cell is 319-360-7140
THANKS a bunch!
#3
Just sent ya a text, send pics an i'll buzz yz when I get 'em
__________________
Throttles- Cleveland Construction 377 Talon
08 OPA Class 1 National Champion
08 Class 1 Geico Triple Crown Champion
08 OPA High Points Champion
10 OPA Class 1 National Champion ( happy now Ed! )
Throttles- Cleveland Construction 377 Talon
08 OPA Class 1 National Champion
08 Class 1 Geico Triple Crown Champion
08 OPA High Points Champion
10 OPA Class 1 National Champion ( happy now Ed! )
#5
no prob Jeff, ya got my number any timer ya need it. Always got to see another Batboat getting redone
__________________
Throttles- Cleveland Construction 377 Talon
08 OPA Class 1 National Champion
08 Class 1 Geico Triple Crown Champion
08 OPA High Points Champion
10 OPA Class 1 National Champion ( happy now Ed! )
Throttles- Cleveland Construction 377 Talon
08 OPA Class 1 National Champion
08 Class 1 Geico Triple Crown Champion
08 OPA High Points Champion
10 OPA Class 1 National Champion ( happy now Ed! )