Re: Gauges, senders and bezels OH MY
 

thanks guys

Im going to leave them in the same order just drop the hour meter and add a depth gauge there or something

I'm sure its easier to pull the whole panel and remove and replace the gauges out of the dash?

Re: Gauges, senders and bezels OH MY
 

I had to make a new panel when I change to the Gaffrig. The VDO's had a special ring around the gauge and tha back of the original panel had a machined piece of lexan thaat the VDo gauges twisted inot. Not to mention the holes for the Gaffrig needed to be larger diameter. Quick and dirty is use a piece of starboard while an aluminum panel is made. I measured up my panel from the original and laid it out in Autocad and sent it off to a fabricator for laser cutting, then powdercoated it black.

Re: Gauges, senders and bezels OH MY
 

When I did my 311 dash, I didnt want to cut all the formula female spade connectors off. Instead I got a hold of MSD and bought a bag of small adapters they use with there ignitions, its a small metal connector with a male spade on one end, bent at a 45, with a #8 hole on the other end. Worked perfect without cutting up the factory wiring.

Re: Gauges, senders and bezels OH MY
 

i installed autometer marine & had a new carbon fiber dash panel made

Re: Gauges, senders and bezels OH MY
 

What is that red plate with the 5 oblong holes? Nice update! Did someone paint that dash black?

Re: Gauges, senders and bezels OH MY
 

Looks like a billet step plate from Trick or Eddie or CP or . . . . F382, I want to know where you got the C/F panel made . . . .

Re: Gauges, senders and bezels OH MY
 

Really like that carbon fiber panel. :cool:

Re: Gauges, senders and bezels OH MY
 

step plate from eddie marine had a hole to cover from an old depth finder, carbon fiber panel i had made at norva plastics inc. in norfolk va .i had one made for my 382 also .did the port side dash panel to .the dash was black

Re: Gauges, senders and bezels OH MY
 

You can get them all over the internet. Just a FYI with those panels. You have to treat them with UV protectent if they do not already have them on it. Carbon Fiber does not like UV and it will turn to crap in a hurry if not protected.

Jon

Re: Gauges, senders and bezels OH MY
 

no problem with UV ,WEB web site www.norvaplastics.com phone # 757-622-9281, my panels are two years old.