Cup Holders
 

I am looking for powder coated cup holders that are 3 5/8" x only 2 1/4" deep for my 382. Cup holders that I have purchased in the past have only been available in 3" depth and they do not sit flush. Does anyone have any knowledge as to where I can get holders of that depth?

Thanks,
JB

just take a dremel tool or a barrel bit on a drill and hog out the bottom under the top to put in the new one's

We can get you the standard ones pretty cheap. I'll check if "shorties" are available. Stanard is 3" deep.

Elite

I will take a look at cutting out the bottom for a deeper opening... Thanks trips