Looking for plastics help
 

Well lets just say one drunk girl with rather large rack flashing another boat fell and destroyed this, any ideas on replacement???? I have no idea where to even look at getting these made

I don't either....but you need to post a pic of the GIRL with the broken pieces.

Lets see the Rack:drink: I think Cuda made a piece for his old 242 or something. May he will be lurking.

Didnt have camera but I will work on a rack shot shouldnt be hard since she was showin em to evey boat that passed by.
Anywho where are ya Cuda, the boat in question is a 1987 223LS Thanks

He is also on speedwake.

Check your yellow pages for a plastics shop. That's probably acrylic (Plexiglas), and can be bent by heating it to just the right temperature with industrial heat guns or a wire heater.

We used Emco Plastics in NJ 973-239-0202 or www.emcoplastics.com & they were great.

Any plastic shop can make it for you , I had to replace ours on the 272 but a big rack did not break it it was my Drunk Azz . :drink:

We had one made by a local fabricator for a Scarab. Like's been said in previous posts - find a plastics or acrylic shop

Would you consider sending parts to Michigan?Theres a guy here who can help you out.