Clear water inticators (Cable replacement)
 

:( I am about to replace the drive cable. One of them is broke. Should I replace them all, or just the one that's broke. Anybody have any tricks of the trade of helpful hints??
Thanks in advance.

Bill Stock

Bill, I would replace all of them they are like tires if one wears they all wear. As far as replacing them , use an old one and pull the new ones by taping them to the old one and gently pulling them through. You may have to cut some wire ties along the way if they jam. If you remove all the old ones except for one they should pull O.K. Good Luck, MFB

I am going to put a emphasis on GENTLY pull them through. I have seen people yank them through and mess up electrical stuff. So take your time it is an easy job but does take time.

Jon

What's a clear water inticator?

Thanks
I was kind of planning on doing them all. Your right about one going and the rest are not far behind. It sure doesn't look like too much fun.

Chart
They are the cable on the drives and the tabs that tell you where the drives and tabs are.

Wish me luck
Bill