|
Cup holders!!
Although they don't fit in the step plates, they make a nice addition to an already really nice dash!
Thanks again to Bill at Diamond Performance! 302-521-0123 http://i1201.photobucket.com/albums/...l/42b19239.jpg http://i1201.photobucket.com/albums/...l/e390b929.jpg http://i1201.photobucket.com/albums/...l/968abcbf.jpg |
I put red anodized in a few years ago when I did the wheel ect, I thought you did too?
Those are a quality lookin piece tho I hope 5 inch hasn't seen those black bolster switches . . . and just where is your glovebox lid bump/stop? huh? :party-smiley-004: |
Originally Posted by Rippem
(Post 3736272)
I put red anodized in a few years ago, I thought you did too?
I hope 5 inch hasn't seen those black bolster switches . . . and where's your rubber glovebox lid bump/stop? huh? huh? ???? :party-smiley-004: I did put the red ones in too, but now with the carbon fiber "red" dash and stainless bezels, I needed a change. They look real nice and they are Billett! Never had the bump stop? Does it go in the little hole there? Factory black switches. I was going to change them out, but realized that the newer one are too easy to activate by accident. Dave |
Originally Posted by axapowell
(Post 3736283)
Never had the bump stop? Does it go in the little hole there? Factory black switches. I was going to change them out, but realized that the newer one are too easy to activate by accident. Dave you get use to it. I seldom activate mine by accident but do find them very easy to use as I adjust often- maybe some flat white Fusion? The bezel would be no problem, and I feel it would stay on the rocker if prepped, multiple THIN coated and cured proper. |
| All times are GMT -5. The time now is 07:39 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.