-   Formula (
-   -   292 SR1 with 1250HP (

Bad vert 04-10-2021 10:24 PM

292 SR1 with 1250HP
Hey guys Iím building a 292 SR1 with 625HP a side and was wondering what kind of speed would I get out of it. Also the transom is notched as well. Should I run 4 or 5 blade props too? Thanks for all input

Unlimited jd 04-11-2021 05:49 AM

Going to need a lot more info to be able to answer those questions.
what year is the boat
Have you measured prop shaft height?
what drives?
625 hp at what rpm? Dyno with marine accessories and exhaust?

Bad vert 04-11-2021 07:43 AM

Bravo 1 drives. The motors were dyno fully dressed. Peak HP was like 5500. Torque was 610 at 4200rpm

the boats a 1989

ph1971 04-11-2021 08:01 AM

Distant Thunder had a very healthy 292 a couple years back and may have some info for you. This probably isn’t a light enough boat for 5 blades on bravo drives. I would guess 28-30p Bravo four blades are going to be close. Mid 80’s if you haven’t raised the drives? Should be fun with that power.

Unlimited jd 04-11-2021 10:06 AM

Who notched the transom? Never seen an sr1 with a transom notch. Was the drive height changed?
should run mid to high 70ís with that power if set up right

Bad vert 04-11-2021 10:40 AM

Iím gonna run standard length drives see what kind of speed I can get out of it then same day out 2 inch shorties on it and see how much I pick up and decide if I should buy shorties or not

Bad vert 04-11-2021 10:41 AM

Also gonna try to raise the x dimension as far as possible. I will find out this week how high I can raise it

SabrToothSqrl 04-11-2021 11:02 AM

Gonna need some pics here!

Bad vert 04-11-2021 11:12 AM

I will get pics when itís all back together hopefully within a month

Nothing personel 353 04-11-2021 12:36 PM

My guess 3 blade 27 pitch 80-85?

All times are GMT -5. The time now is 12:24 PM.

Copyright © 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.