07 38 600sci
#1
Registered
Platinum Member
Thread Starter
iTrader: (1)
Join Date: Sep 2003
Location: Fort Erie Ontario Canada
Posts: 521
Likes: 0
Received 1 Like
on
1 Post
07 38 600sci
I am debating pulling motors or doing top end and cam change in boat. Just got boat, it's put away till spring and was wondering if anyone has changed cam in forward motor by removing back seat.Don't know if it is removable? Not going to drill hole.
Thanks Joe
Thanks Joe
#2
Registered
Forward motor will have to be pulled. Engine compartment front wall is fiberglass. There are actually two walls, the inner for the engine compartment and then another which the seat bolts to.
Would like to hear your results if you do the cam upgrade. Others have dynoed at 860 with the 700 cam and the ECM tuned.
Hope to see your boat at Buffalo Poker Run.
Would like to hear your results if you do the cam upgrade. Others have dynoed at 860 with the 700 cam and the ECM tuned.
Hope to see your boat at Buffalo Poker Run.
#3
Registered
Platinum Member
Thread Starter
iTrader: (1)
Join Date: Sep 2003
Location: Fort Erie Ontario Canada
Posts: 521
Likes: 0
Received 1 Like
on
1 Post
Thanks for reply, better way to do top end anyway's, myself and some budies are talking about run, hope to do it.
Ran stage 2 for 10 hrs near end of season, but doing top end anyway's might as well do cams to let it breath.
Thanks again
Joe
Ran stage 2 for 10 hrs near end of season, but doing top end anyway's might as well do cams to let it breath.
Thanks again
Joe